Tyvek® 600 Plus Coverall with Socks | Type 4-B/5-B/6-B | White

The DuPont™ Tyvek® 600 Plus with socks is a white hooded coverall with attached socks and knee-length boot flaps, and stitched and over-taped seams. It offers Type 4-B, 5-B and 6-B protection, with an inward leakage figure of 0.2%, the lowest in the Tyvek® range. It has a Tyvek® zip with self-adhesive zip flap and chin flap for a tight seal to the mask, tunnelled elastication at the face, wrists and ankles for a good fit and reduced contamination and linting, glued-in waist elastic and thumb loops. Tyvek® is made from flash spun high density polyethylene, permeable to air and water vapour yet repelling water-based liquids and aerosols, with an excellent barrier against fine particles and fibres down to 1 micron. Ultra-low-linting and antistatically treated on both sides. Silicon non-added.

Features

• Certified to Regulation (EU) 2016/425

• Chemical protective clothing, Category III, Type 4-B, 5-B and 6-B

• EN 14126, barrier to infective agents

• EN 1073-2, protection against radioactive contamination, class 2

• Antistatic treatment to EN 1149-5, on both sides

• Attached socks and knee-length boot flaps

• Stitched and over-taped seams for protection and strength

• Tyvek® zip with self-adhesive zip flap and chin flap

• Tunnelled elastication at face, wrists and ankles, glued-in waist elastic

• Thumb loops

• Ultra-low-linting, silicon non-added

Applications

• Maintenance and dismantling in the nuclear industry

• Pharmaceutical manufacturing

• Research and biosecurity laboratories

• Medical applications and exposure to biological hazards

Technical Data

• Fabric: Tyvek®, flash spun HDPE

• Basis weight: 41.5 g/m² (DIN EN ISO 536)

• Weight: under 250g per garment

• Melting point: approximately 135°C

• Surface resistance, inside and outside: <2.5 x 10⁹ Ohm (EN 1149-1, 25% RH)

• Type 4 high level spray test: pass (EN ISO 17491-4, Method B)

• Type 5 inward leakage: 0.2% (EN ISO 13982-2)

• Type 6 low level spray test: pass (EN ISO 17491-4, Method A)

• Nominal protection factor: >50 (EN 1073-2, class 2/3)

• Seam strength: >75 N (EN ISO 13935-2)

• Resistance to water penetration: >10 kPa (DIN EN 20811)

• Abrasion resistance: >100 cycles; flex cracking: >100,000 cycles

• Repellency to 10% sodium hydroxide and 30% sulphuric acid: >95% (EN ISO 6530)

Size & Packaging

• Sizes: SM to 3X. XS and 4X to 7X are made to order, please enquire

• Individually packed, Pack / 80

Unit of Sale

• Each